Hypex FusionAmp FA251Mono 250W
The FusionAmp is our new plate amplifier range, powered by our new mains powered NCORE modules. There are one, two and three way systems available, each with balanced and unbalanced analog inputs. The one-way models also have a high level analog input. The multi-way models have a digital input instead.
This FusionAmp can be the basis of e.g. a powerful active subwoofer or a one-way monitor. The FA251 has one powerful 250 Wrms Ncore® amplifier.
The FusionAmp is designed to be mounted in vertical or horizontal position. The FusionAmp may be tilted 45° in both direction as depicted. Vent holes should not be covered and free convection should not be impeded.
To protect your valuable drivers, the DSP does not contain a ﬁlter out of the box. A ﬁlter needs to be conﬁgured and uploaded using Hypex Filter design (HFD) software before the FusionAmp will produce an output signal. Please refer to the online HFD manual for more information. Since the FusionAmp’s DSP does not contain a ﬁlter by default, you need to get started with HFD. This free software can be downloaded from the Hypex website. You can start getting acquainted with the software, even without a Hypex product connected. An elaborate guide on how to design the ﬁlters can be found on the Hypex website.
The Fusion Amp must be mounted into the speaker cabinet with 8 or 10 screws, not included. Hypex recommends Phillips head screws, 4.3 x 25.4 mm.
Fusion-Amps can also be operated with remote control for volume control and source selection. Our well known Hypex Remote Control can be used for this. To use a remote, you will need the new IR-receiver kit, also available as a separate module via the pull-down menu. Specs
Mains voltage input
100-120Vac / 200-240Vac ±10%
1 channel / 1 way
Analogue balanced XLR in and through
Analogue unbalanced RCA input
High level input
USB 2.0 configuration interface
15 biquads per amplifier
Three selectable presets for filters
Meet the family
The Fusion Amp family consists of the following models: