The highest quality speaker driver units that you can find.

S115V-HF-16

2 left in stock
GRS S115V-HF-16, Replacement, 25mm (1in) Compression Horn Driver Tweeter for Yamaha Club Series S115V Speakers. 
CA$83.25Each
  • S115V-HF-16
  • GRS

GRS S115V-HF-16, Replacement, 25mm (1in) Compression Horn Driver Tweeter for Yamaha Club Series S115V Speakers. 

Bring those old and worn down Yamaha S115V Club Series speakers back to life with the GRS S115V-HF-16 compression driver. Designed to be a drop in replacement, these can be swapped in only a few minutes with a couple basic tools.
 
Key Features
  • Designed as a drop-in replacement for the venerable Yamaha S115V compression drivers
  • Titanium diaphragm for matched sonic qualities
  • A large rear chamber for smoother low treble performance
  • Works perfectly with stock S115V crossovers
  • Offers smoother overall response than the stock compression drivers

Don't just replace - upgrade. Bring those old and worn-down Yamaha S115V Club Series speakers back to life with the GRS S115V-HF-16 Compression Driver. Designed to be an improvement of the original, these can be swapped in only a few minutes with a few basic tools.

The GRS S115V-HF-16 replacement tweeter has been designed to improve the performance of your Yamaha Club Series speakers by optimizing crossover summation of the original installed woofers and improving performance in the highest octave. When the GRS S115V-HF-16 is paired with the GRS S115V-LF-8 woofer, you can expect an improvement in off-axis response, perfect summing at the crossover point, and increased detail and clarity in the high-end providing performance where you expect it most.

Improved Performance

This driver shares all of the important design features of the original, such as a titanium diaphragm, 16-ohm impedance and even offers a smoother overall response and better extension above 8kHz than the original, all using the stock Yamaha crossovers. The GRS engineers thought of everything, even down to the mounting thread size and spacing. Utilizing 1/4" - 20 TPI holes spaced 3" on center, even the stock mounting hardware can be used. 

A large rear chamber and ferrite motor structure bring everything together, allowing this driver to hold up to the harshest environments of live audio. Combine all of these traits together and you get not only a great, inexpensive replacement, but a solid improvement over the original - all while maintaining the strength and durability that allows it to last for years to come.

Add a review

Be the first one to review this product.

Your review is submitted for approval.