|Summary||Dayton Audio APA100 Class AB Stereo Amplifier 60 WPC
The Dayton Audio APA100 high fidelity power amplifier switches sources and powers on (in auto-on mode) automatically when a source signal is detected. Two-sources, two-channels, and Class AB topology make Dayton Audio’s APA100 amplifier the heavyweight in its class. The APA100 features two pairs of RCA line level inputs and a loop-out from the second source to feed additional zones, receivers, or other devices. Use the APA100 for additional power when connected to a multi-zone audio system, or by itself to power a stereo speaker system.
The APA100 is rated at 75 watts RMS per channel into 4 ohms, and 60 watts RMS per channel into 8 ohms. In bridged mono mode, both amplifier channels are combined for high-power monaural output. The amplifier is rated at 160 watts RMS into a single 8 ohm load when bridged. Each amplifier output channel incorporates robust protection circuitry for reliability and safety.
Specifications: Output power: 60 watts RMS @ 8 ohms, 75 watts RMS @ 4 ohms, 160 watts RMS @ 8 ohms (minimum impedance) bridged mono
Total harmonic distortion: 1.0% @ 1 kHz
Signal to noise ratio: 100 dB, A-weighted
Frequency response: 10-30,000 Hz +0.0 dB/-3.0 dB
Input sensitivity: 900 mV (50 watts @ 8 ohms)
Crosstalk: 70 dB @ 1,000 Hz
Power: 120 VAC, 60 Hz, 4.2A
Dimensions: 16.5″ W x 8″ D x 2.5″ H.
APA100 Class AB Stereo Amplifier 60 WPC
Availability: Available on backorder
Dayton Audio APA100 Class AB Stereo Amplifier 60 WPC.
Connect with the Dayton Audio APA100 amplifier and enjoy the convenience of auto-on and auto-source switching technology.
Available on backorder
|Dimensions||12 x 50 x 26 cm|
100 – 110
2.5 – 5 kgs