LBB-3V2
3 left in stock
Dayton Audio LBB-3v2 3 x 18650 Lithium Battery Charger Board/Module 12V with Charge Protection
CA$20.91Each
- LBB-3V2
- DAYTON AUDIO
- Electronics
| Product Specifications | |
|---|---|
| Manufacturer | DAYTON AUDIO |
| Summary | Dayton Audio LBB-3v2 3 x 18650 Lithium Battery Charger Board/Module 12V with Charge Protection
Dayton Audio's LBB-3 compact battery holder board delivers high current portable power to small amplifiers, 50W amp boards, or other 12 VDC projects by combining the voltage from three 18650 Li-Ion batteries (sold separately). It's small enough to fit inside a portable speaker and has multiple 12 VDC outputs to power an amp, tone control, Bluetooth, and other preamp component boards. Enjoy the extended listening time you get from Li-Ion batteries on a single charge. 18650 Li-Ion batteries come in a variety of amperages, and to get the longest playtime from a 50W amplifier or amp board use at least 2600mAh batteries. There's no need to remove the batteries from the holder because the Dayton Audio LBB-3 has a built-in charge circuit. Just plug in a power supply and the over/under charge circuit prevents correctly installed batteries from overcharging and fully discharging, shortening their life. The LBB-3 battery board needs a 5 to 24 VDC power supply (sold separately) to start the charging process and to start its output power. This enables you to listen to music while the batteries are charging with this amazing battery holder. To view charging and battery status press the push button on the battery board, or use Dayton Audio's LBB-5CL push button and LED kit (sold separately) to view status externally and also adds extra DC input/output options. If you remove a battery, the power supply must be plugged into the holder for the battery board to start working again when the battery or batteries are reinstalled. The polarity of the batteries must match the polarity of the battery holder to prevent damage. To charge and power 5VDC devices, and recharge the LBB-3v2 battery board outside your project use Dayton Audio's LBB-5EB. It has two USB ports that put out 2A of current for smart phones, tablets, and other 5 VDC devices. The board also has a 2.1 x 5.5 tip positive DC coax power jack so you don't have to solder in an external charging jack. To make it even easier the LBB-5EB includes a 6-pin 8" wiring harness that plugs directly into the battery board J5 socket. Make sure you plug into the expansion socket and not the external LED socket. Note: The Dayton Audio LBB-3 is an independent battery holder board and it's design is not for Dayton Audio KAB boards. Use Dayton Audio battery board KAB-BE with Dayton Audio KAB Bluetooth amp boards. Specifications: • Output voltage: 12 VDC • Input voltage required: 5 to 24 VDC at least 2A recommended • Maximum current draw: 5A • DC coax jack size: 2.1 x 5.5 mm center (+) polarity • Batteries: Three x 18650 Li-Ion (sold separately) • Dimensions: 3.61" W x 2.72" D x 1.34" H (92 x 69 x 34 mm). |
| FILENAME | ACTION |
|---|---|
| lbb3v2.pdf | Download |
Subscribe to Our Newsletter
Subscribe to our newsletter & get notification about discounts.